NEVER pry a powder load out of the chamber. Remington ® Power Fasteners are manufactured from special steel and heat treated to produce a very hard yet ductile fastener. NEVER use common nails or other materials as fasteners.
Remington ® Powder Loads are available in four power levels with gray (1) beingġ1 101274 7. NEVER carry fasteners or other hard objects in the same pocket or container with powder loads. A color blind person must take extra precautions to prevent the chance of mixing the powder loads of various levels. NEVER leave unfired powder loads on floors or work surfaces. NEVER use a powder actuated tool in an explosive or flammable atmosphere or when non sparking tools are required.
ALWAYS use the spall shield when driving directly into concrete or steel. DO NOT drive power fasteners into concrete less than three times as thick as the intended fastener penetratĩ 101274 WATER 489-33 30 489- 3. DO NOT drive power fasteners into steel base material less then 3/16" thick, within 2" of a weld, within 1/2" of the edge, or within 1" of another power fastener. Materials of this type tend to shatter and create hazard from flying particles. NEVER attempt to drive power fasteners into very hard or brittle materials including, but not limited to cast iron, glass, tile, stone, brick, or hardened steel.
#REMINGTON MODEL 490 PARTS CRACKED#
NEVER make fastenings in spalled or cracked areas. ALWAYS know the thickness and type of base material into ħ 101274 Safety Precautions 3. NEVER drink alcoholic bever- ages or take medications which impair your vision, balance or judgement before using a powder actuated tool. An operator taking medication should take extra precau- tions while handling the tool. If the tool is dropped, inspect for damage and repair it before cĦ 101274 Safety Precautions 7. Keep powder loads of different power levels in separate containers. ALWAYS store UNLOADED powder actuated tool and powder loads in a locked container. NEVER point a powder actuated tool at anyone. NEVER carry or pass a loaded powder actuated tool. ALWAYS clear the work area on all sidĥ 101274 Safety Precautions 4. NEVER place your finger on the trigger until the muzzle of the tool is against the work surface. Accidental discharge can cause serious injury. ALWAYS make sure the work area is clean from loose material and debris. We expressly disclaim any liability for any injury to persons or damage to property which result from your failure to take the pĤ 101274 5.
Read carefully and become familiar before operating to avoid serious injury. ģ 101274 WARNING ICON G 001 W arning: Safety Precautions The following pages contain detailed warnings, cau- tions, and rules of safe operation. Impor tant: ® G 028 490-01 REMINGTON ® Powerdriver Models 489 and 490Ģ 101274 REMINGTON 490-02 INDEX Warning: Safety Precautions.
#REMINGTON MODEL 490 PARTS MANUAL#
This manual should always accompany the tool and be transferred with it upon change of ownership. ™ G 029 Operating Instructions Read this manual and all labels carefully before operat- ing your powder actuated tool. POWDER ACTUATED TOOL MANUFACTURERS´ INSTITUTE INC.
0 kommentar(er)
